![]() ![]() ![]() Uncomment if hdmi display is not detected and composite is being output By default it will be display’s size minus Goes off screen, and negative if there is too much border Uncomment the following to adjust overscan. ![]() Uncomment this if your display has a black border of unused pixels visibleĪnd your display can output without overscan Uncomment if you get no picture on HDMI for a default “safe” mode Some settings may impact device functionality. So my issue seems to be with the Raspian Buster GUI not detecting multiple displays after installing the display driver.īelow is the config.txt file after the drivers were installed: I did notice however, that i have one python script that i can run that will run the Omxplayer and output video on a selected HDMI and this seems to work for both displays. I then followed the instructions that came with the displays to install the 1024圆00 driver and then it booted up ok, but only one display would be detected by the GUI. ![]() When I first booted up with both screens, it wouldn’t detect them after boot until I unplugged the HDMI cables and replugged them back in and then the GUI would display. I have a new Rpi4 and have connected 2 x 7" HDMI displays. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |